CURT 55537 transportlīdzekļa pusē pielāgota 4 kontaktu piekabes vadu instalācija, der Select Dodge Caravan, Grand, Chrysler Town and Country

Brand:CURT

3.6/5

74.27

Ja jūsu automašīna nav aprīkota ar vadiem piekabes vilkšanai, CURT pielāgota elektroinstalācija ir ideāls risinājums. Pielāgota vadu instalācija — saukta arī par T savienotāju — ir vienkārša, plug and play elektriska ierīce, kas tiek pievienota jūsu automašīnas elektrosistēmai un nodrošina standarta, universālu piekabes vadu savienojumu. Tas tiek darīts, izmantojot divus vai vairākus transportlīdzeklim raksturīgus, ar OEM saderīgus savienotājus, lai pievienotu aizmugurējo lukturu komplektam, novēršot nepieciešamību pēc griešanas, savienošanas un lodēšanas uzstādīšanas laikā. Pielāgotas vadu instalācijas ir pielāgotas transportlīdzekļiem, un, lai gan tās nav pieejamas visiem transportlīdzekļiem, tās piedāvā vienu no ātrākajiem, vienkāršākajiem un drošākajiem veidiem, kā savienot transportlīdzekli vilkšanai. Šajā konkrētajā spraudņa instalācijā ir četrvirzienu plakana savienotāja ligzda, un tā ir izstrādāta kā pielāgota vadu instalācija, lai tā atbilstu noteiktiem Dodge Caravan, Dodge Grand Caravan un Chrysler Town and Country gadiem (lai pārbaudītu sava transportlīdzekļa saderību, skatiet informāciju par lietojumprogrammu ). Tam ir visi nepieciešamie vadu komponenti, lai izveidotu uzticamu piekabes vadu savienojumu, kā arī putekļu vāks, lai savienotājs būtu tīrs, kad to neizmanto. Jums ir prātā priekšstats par savu nākamo galamērķi — varbūt tā ir laiva, kas nolaižas jūsu iecienītākajā makšķerēšanas vietā, varbūt tas ir kempings, no kura paveras skats uz kādu no dabas šedevriem, vai varbūt tā ir nākamā lielā darba vieta. Tomēr šī attēla pārvēršana realitātē prasa vairāk nekā tikai sapņošanu. Tas prasa stabilu savienojumu un pareizo enerģijas daudzumu. CURT pielāgota elektroinstalācija ir izgatavota, izmantojot dažas no vismodernākajām tehnoloģijām nozarē, un ir paredzētas vieglai uzstādīšanai, nodrošinot ilgstošu elektrisko savienojumu jūsu sakabes āķa uzstādīšanai.

PUTEKĻU KĀRTA. Lai veicinātu ilgstošu lietošanu un izturību pret laikapstākļiem, šai 4-polu piekabes apgaismojuma vadu instalācijai ir gumijas putekļu pārsegs. Kad tas netiek lietots, tas viegli pieguļ četrvirzienu plakanajam savienotājam, aizsargājot to pret āra elementiem. VIEGLA SATRAUKŠANA. Pateicoties šīs transportlīdzekļa ligzdas ergonomiskajam dizainam, piekabes vadu un piekabes lukturu pievienošana ir vienkārša. Tam ir izciļņi augšpusē un apakšā, lai nodrošinātu labāku satvērienu, pievienojot piekabei vai atvienojot to. TRANSPORTLĪDZEKĻIEM. Šī pēcpārdošanas transportlīdzekļu piekabju vadu instalācija ir paredzēta noteiktiem Dodge Caravan, Dodge Grand Caravan un Chrysler Town and Country gadiem. STANDARTA SAVIENOTĀJS. Šo iespraudamo 4 plakanu piekabes vadu var izmantot, lai savienotu piekabes aizmugurējos lukturus, bremžu signālugunis un pagrieziena rādītājus. Četrvirzienu piekabes gaismas vadi ir populāri dažādās piekabēs, pievienojot daudzpusīgas vilkšanas iespējas jūsu transportlīdzeklim. VIEGLI UZSTĀDĪT. Nekādas griešanas! Nav savienojuma! Šis piekabes vadu komplekts tiek pievienots esošajiem jūsu transportlīdzekļa rūpnīcas vadiem un aprīkots ar standarta aizmugurējo 4 kontaktu piekabes vadu savienotāju piekabes pievienošanai un vilkšanai.
Brand CURT
Brand ‎CURT
Country of Origin ‎USA
Customer Reviews 4.6 4.6 out of 5 stars 196 ratings 4.6 out of 5 stars
Exterior ‎Smooth
Is Discontinued By Manufacturer ‎No
Item Dimensions LxWxH 9 x 4 x 3 inches
Item model number ‎55537
Item Weight 0.31 Pounds
Item Weight ‎5 ounces
Manufacturer ‎Curt Manufacturing
Manufacturer Part Number ‎55537
Material Rubber
Model ‎Custom Wiring
OEM Part Number ‎55537
Product Dimensions ‎9 x 4 x 3 inches

3.6

13 Review
5 Star
74
4 Star
17
3 Star
3
2 Star
1
1 Star
4

Uzrakstiet savu atsauksmi

Jūsu e-pasts netiks publicēts. Visi obligātie lauki ir atzīmēti ar*

Scritto da: Keith
Quick and easy
This was very easy to install, less than 20 minutes. Works great.
Scritto da: Tricker
Towing with lights is good
Read instructions, installed, lights up my trailer. Saved a bunch of money diy baby!
Scritto da: Alicia Mick
Ok
I wish there was a way to route it a diffrent way but had to come out the back when I use it because of the stow n go but it works fine just tuck it back in the trunk when not using
Scritto da: D. WALTER
Took a little maneuvering to install
When I bought this trailer light wiring harness for my 2005 Chrysler Town and Country, I thought it would be the same as with my 2005 Dodge Durango, and go on in a couple of minutes, but I was severely wrong. With this wiring harness, you have to push the ends of the wiring harness through a couple of prefab holes in your auto body. The problem with this is that there is insulation between the interior and exterior body panels, and the holes you need to push the wiring harness through can get pretty tight. The left side tail light was fairly easy with a larger hole in the body panel, I was able to put my hand in farther, and push the wiring harness easier. The Right side taillight was a little harder because the body panel hole on the interior was smaller, and a little lower than the exterior hole, so much more difficult to maneuver through the body. We ended up cutting the end of the right side wiring harness off, and running the wire through the panel, and then reattaching the harness end to the wire once it was through the body. Also, something I wasn't aware of with this harness is that the 4 pin connector is not maintained on the outside of the vehicle. This wiring harness stays inside the vehicle until you are ready to use it, and then you run the wires out through the back door whenever you're going to use it. The part I don't like about this harness is shutting the door on the wires. I know that there is weather stripping there, and it probably won't cut the wires by being closed on them, but I just feel it might degrade the life of the harness... Otherwise, so far so good. Decent wiring harness, somewhat difficult installation, but still functional, and decent quality.
Scritto da: Nicholas Maddox
Easy to install
Easiest install for any wiring project I’ve ever done!
Scritto da: John F
Quick use!!
Took about 5mins to install. I did not run it back through the body. I just ran the wires under the light assembly. Then pushed the wires inside the van 5mins tops. Didn't care for the ground wire. Had to use a drill Tel screw to the body. They could've tied that into the other white wires since the body harness for the lights is already grounded. Other than that no problems.
Scritto da: Keith J Rigden
Get it
Pretty easy to install in my 06 Grand Caravan. Routing to the passenger side requires you to fish it to the light cavity. Get a good look at what's going on there before you tie on. Wish the set was longer. Watched one video, but it was for another brand. This product is too short to route it their way, which is a little cleaner, but not a big deal. Only reason for knocking a star off. Worth every extra penny to not have splice anything!!
Scritto da: Ashish Desai
Very easy to install and worked with no issues
The harness is super easy to install on a 2005 dodge grand caravan sxt stow and go. Took about 20 minutes with no prior experience of knowing anything dodge or harness wiring. The self tapping ground screw worked instantly under the gamble and the length of excess wire is about 15 inches which is plenty to reach my trailer. Literally you can do this by watching a YouTube video on your phone and doing it same time. Definitely buy this kit and do not pay to get it installed ..you can do It yourself
Scritto da: Kevin from Calgary
Works well for my little trailer with LED lights.
Works well with my little trailer. Note that this kit does not contain a powered converter, so your trailer lights are powered from the vehicle's tail light wiring. If your small trailer has LED lights, this setup is fine. On my 2005 Grand Caravan, this kit will allow the trailer connector to extend outside the tailgate by a foot, or perhaps a little more. It takes a fair bit of cutting in the existing tail light wiring grommets for the hole to be large enough to push the connectors through to the space behind the taillights. That small tube of black silicon sealant is to reseal the grommet where you cut through. I used coil-style plastic wire loom to protect the wiring as it exits under the tailgate.
Scritto da: JP
Price was right, easy to install
Great price point, installed on an 04 caravan, took about an hr but never installed a trailer harness before. Good product!
Scritto da: Mr.Kent
works great.
no problems, works great.
Scritto da: Amazon Customer
... cable cannot be stored in the tire jack compartment like the other brand
It works with the exception that the plug is very tight and the cable cannot be stored in the tire jack compartment like the other brand. Minor problems. Seems to work OK.
Scritto da: Dompti
????
Parfait mais je l’es retourner je n’avais plus besoin.

Saistītie produkti

Atklājiet mūsu starptautisko tīklu

Mēs piegādājam uz 28 valstīm, vairāk nekā 200 000 produktu. Esiet informēts, abonējiet biļetenu.

Array