Eastman 35312 atloku atzara gala uzgalis ar slīdošo savienojumu, 1-1/2 collas x 8 collas, balts

Name: Eastman 35312 atloku atzara gala uzgalis ar slīdošo savienojumu, 1-1/2 collas x 8 collas, balts
Brand: Eastman
SKU: 0091712098461
Price: 26.04 EUR
Availability: InStock

Brand:Eastman

3.3/5

€
26.04

Ir aprīkots ar slīdošo savienojumu ātrai un vienkāršai uzstādīšanai. Aprīkots ar 7/8 collu OD stieņu izvadu uzstādīšanai trauku mazgājamā mašīnā. Paredzēts, lai savienotu armatūras kanalizāciju ar slazdu cauruļveida santehnikas lietojumos. Izgatavots no lieljaudas polipropilēna, lai nodrošinātu izturību pret sadzīves ķimikālijām. Atloku zara gala izmērs ir 1–1/2 collas x 8 collas.

Summa

Pievienot grozam Pērc tagad

EAN: 0091712098461

Kategorijas instrumenti un mājokļa labiekārtošana, Servisa un fitnesa piederumi, caurules, cauruļu savienotājelementi un piederumi, cauruļu savienotājelementi,

Brand	Eastman
Color	White
Connector Type	Flange, Trap
Exterior Finish	White
Item Dimensions LxWxH	8.4 x 3.3 x 1 inches
Material	Polypropylene
Number Of Pieces	1
Size	1-1/2 inch x 8 inch

5 Star

4 Star

3 Star

2 Star

1 Star

Uzrakstiet savu atsauksmi

Jūsu e-pasts netiks publicēts. Visi obligātie lauki ir atzīmēti ar^*

Jūsu vērtējums

Scritto da: sam

Works

The dishwasher port is a tad small but it worked

Scritto da: Lakeviews

Slip joint portion of this product it too shallow (short).

The slip joint ("S/J") section of the tailpiece is too short to provide adequate stability. This product is advertised as working as a direct connect, it can butt up against the sink drain, or as a slip joint, allowing it to partially slip over another section of drain pipe. In my case I only had enough clearances under the sink to mount this item horizontally between the P trap and the stub out from the wall. Mounting it horizontally introduces a bit of torque on the joint where this product slides over the P trap's exit pipe. The slip joint portion of this product is only about 3/4" deep (2mm). To provide sufficient stability it should really be at least an inch deep (allowing the other pipe to slide into it at least an inch. I thoroughly looked at it and the alternatives carried by Amazon and decided to go with this product, even though I suspected the shallowness of the slip joint might be a problem. It is in place and doesn't leak yet, but it's not been subjected to many dishwasher runs. The pulsing of jets of water from the dishwasher during the drain cycle may cause it to fail and start to leak.

Scritto da: C. LuzHoxsie

2nd best option if a garbage disposal is not available.

I had a temporary sink while my counters were getting fabricated and this worked well since I did not have a garbage disposal to hook my dishwasher too.