Groz 4-daļīgs adatu perforatoru komplekts

Name: Groz 4-daļīgs adatu perforatoru komplekts
Brand: Groz
SKU: 8901486267685
Price: 48.43 EUR
Availability: InStock

Brand:Groz

2.5/5

€
48.43

Misiņa perforatori ir ideāli piemēroti smalkam darbam ar mīkstiem materiāliem. Nesabojājas, tie nerada bojājumus materiālam, pie kura tiek apstrādāts. Izmanto arī, lai radītu maigu sākotnējo kustību ar tērauda perforatoru, ko vēlāk izmanto, lai pabeigtu darbu.

Summa

Pievienot grozam Pērc tagad

EAN: 8901486267685

Kategorijas instrumenti un mājokļa labiekārtošana, Industriālie un zinātniskie priekšmeti, Elektroinstrumenti un rokas darbarīki, rokas darbarīki, Lāpīšanas naži, Durvotāji tapām,

4 daļu komplektā ietilpst: 1/8, 5/32, 3/16 un 1/4; Iepakots vinila maisiņā. 4 collu garums ar apaļu kātu. Viendaļīga konstrukcija ar tērauda korpusu un misiņa perforatoru. Nesabojājas: ideāli piemērots delikātam darbam ar mīkstiem materiāliem, jo tie neizraisa apstrādājamā materiāla bojājumus. Ražots no cieta misiņa.

Country of Origin	India
Item model number	26768
Manufacturer	Groz
Package Dimensions	6.81 x 4.09 x 1.42 inches; 9.52 Ounces

5 Star

4 Star

3 Star

2 Star

1 Star

Uzrakstiet savu atsauksmi

Jūsu e-pasts netiks publicēts. Visi obligātie lauki ir atzīmēti ar^*

Jūsu vērtējums

Scritto da: THC2

Bad Quality Control from Groz

I had planned to give these punches as a gift, but what I received is not giftable so I plan to return them. For starters, the bottom seam of the plastic/vinyl pouch was ripped so when I picked up the pouch, all the punches fell out onto the table, leaving behind a few dings and one nice chip in the finish. But that's my fault: I should have opened them over the trash can instead. The punches themselves look like they were assembled into a set from individual punches that they had laying around the shop. A few of them are shiny and new, others look dull, like they've been sitting around for a while. The tapers and especially the knurling are different on each punch. The 1/8" punch looks like the knurling isn't even finished! It looks like it should have spent a bit more time on the lathe. Finally, the size markings/engravings on the ends of the punches are of various quality ranging from good (on the 1/16" and 7/32" punches) to illegible (on the 5/16") to meaningless on the 1/8" punch where it only reads "3 - 0", whatever that means. Taken as a whole, all these defects and oddities tell me that the quality control at Groz is poor these days. I'd be afraid they'd break with a light tap from a small plastic gunsmith's hammer and I certainly would not give them as a gift. So they are going back to Amazon unused and I am never thinking about Groz tools again.

Scritto da: Marc B.

Good quality and I like the longer ones for better hand possitioning.

Very good product!