Rain Bird 12DSH dubultā izsmidzināšanas sprausla, 180° pusloka raksts, 9' - 12' izsmidzināšanas attālums pusaplis 180° raksts 180° pusloks

Brand:Rain Bird

3.7/5

23.37

PRODUKTA APRAKSTS Rain Bird 12DSH Dual Spray 180° Half Circle Pattern Pattern Precitation Rate Sprausla, regulējams 9' līdz 12' Smidzināšanas attālums, 23° Trajektorija. Šai īpašajai sprauslai ir divas izsmidzināšanas atveres, lai uzlabotu ciešu laistīšanu un vienmērīgāku ūdens sadali. Unikāls patentētais apakšējais dizains samazina laistīšanas laiku, patērē par 30% mazāk ūdens un samazina ūdens izšķērdēšanu vējainā laikā. Vietas, kas atrodas tuvu galvai, vienmērīgi pārklāj, samazinot sausos brūnos plankumus. Nerūsējoša plastmasas un nerūsējošā tērauda konstrukcija ilgam kalpošanas laikam. nerūsējošā tērauda regulēšanas skrūve regulē plūsmas ātrumu no 1,8 līdz 2,6 galoniem minūtē un izsmidzināšanas attālumu no 9' līdz 12'. Nofiksētais skrūvju slots novērš skrūvgrieža izslīdēšanu regulēšanas laikā. Sprausla izsmidzina 180° pusapļa rakstu 23° trajektorijā un der visiem Rain Bird smidzinātājiem un krūmu adapteriem. Smalkas sieta filtra ekrāns nodrošina precīzu rādiusa regulēšanu un aizsargā apakšējo atveri no gružiem. Rain Bird MPR sprauslām, kas ir uzticamas gadu desmitiem, ir Matched Precipitation Rate ūdens sadales tehnoloģija. Sprauslas ar dažādiem lokiem un rādiusiem var jaukt vienā zonā neatkarīgi no smidzināšanas regulēšanas, un tās joprojām saglabā vienmērīgu ūdens sadales ātrumu. Ir pieejama plaša MPR sprauslu izvēle, lai ūdens sadali varētu pielāgot jūsu ainavas unikālajām un daudzveidīgajām vajadzībām. MPR sprauslas ir izstrādātas, lai nodrošinātu vienmērīgu pārklājumu, nodrošinot, ka jūsu zāliens ir zaļš un bez sausiem vai brūniem plankumiem. Citas pieejamas Dual Spray MPR sprauslas (nopērkamas atsevišķi) ir: 360° pilna (12DSF) un 90° ceturtdaļa (12DSQ) modeļi. Rain Bird “Ražotāja saprātīga ūdens izmantošana Rain Bird Corporation ir privāts uzņēmums, kas dibināts 1933. gadā Kalifornijas lauksaimniecības uzplaukuma laikā. Mēs esam atzīti par vadošo apūdeņošanas produktu un pakalpojumu ražotāju un pakalpojumu sniedzēju pasaulē. Ar tirdzniecības birojiem visā pasaulē; mēs piedāvājam vairāk nekā 4000 ūdeni taupošu apūdeņošanas produktu vairāk nekā 130 valstīs. Kopš pašiem pirmsākumiem Rain Bird ir ražojis un piedāvājis nozarē visplašāko augstas kvalitātes apūdeņošanas produktu klāstu: fermām, golfa laukumiem, sporta arēnām, komerciāliem objektiem un mājām. Pēdējo 80 gadu laikā Rain Bird ir saņēmis vairāk nekā 450 patentu visā pasaulē. Ieskaitot pirmo apūdeņošanai 1935. gadā, izmantojot mūsu sākotnējo triecienpiedziņas smidzinātāju (ASV patents Nr. 1 997 901), kas radīja revolūciju lauksaimniecības pārtikas ražošanā un ievadīja jaunu ēru apūdeņošanā visā pasaulē. 1990. gadā Amerikas Lauksaimniecības inženieru biedrība šo oriģinālo trieciensmidzinātāju atzina par vēsturisku orientieri. Mūsu produkti aptver visus apūdeņošanas aspektus… taimerus/kontrolierus, uznirstošos rotācijas smidzinātājus, uznirstošos smidzināšanas galviņas smidzinātājus, sprinkleru sprauslas, apūdeņošanas vārstus, pilienveida apūdeņošanu, drenāžu un daudz ko citu. Šie produkti ir izvēlēti un uzstādīti visā pasaulē lielākajos un prestižākajos dzīvojamo, komerciālo, lauksaimniecības un golfa laukumu apūdeņošanas projektos. Rain Bird ir apņēmies īstenot The Intelligent Use of Water™, kas aptver ne tikai produktus, bet arī izglītību, apmācību un pakalpojumus nozarei un sabiedrībai. Mūsu mantojums ir izstrādāt un ražot tikai augstākās vērtības un kvalitātes produktus. Mēs esam pateicīgi, ka esam saņēmuši daudzas atzinības balvas no daudziem mūsu vērtīgajiem partneriem. Lietus putns “Saprātīga ūdens izmantošana

Izgatavots no ļoti izturīgiem UV un ķīmiski izturīgiem materiāliem, lai nodrošinātu ilgu kalpošanas laiku. Nerūsējošā tērauda regulēšanas skrūve regulē plūsmas ātrumu un izsmidzināšanas attālumu. Novērš sausos brūnos plankumus galvas tuvumā. Savietojams ar visiem Rain Bird uznirstošajiem smidzinātājiem. 180° pusapļa raksts ar regulējamu izsmidzināšanas attālumu no 9' līdz 12'. Patērē par 30% mazāk ūdens; samazina ūdens izšķērdēšanu vējainā laikā. Divas izsmidzināšanas sprauslas izcilai tuvu laistīšanai.
Brand Rain Bird
Color Brown/Black
Country of Origin USA
Customer Reviews 4.7 4.7 out of 5 stars 276 ratings 4.7 out of 5 stars
Domestic Shipping Item can be shipped within U.S.
International Shipping This item can be shipped to select countries outside of the U.S. Learn More
Is Discontinued By Manufacturer No
Item Dimensions LxWxH 0.89 x 0.89 x 2.1 inches
Item model number 12DSH
Item Weight 0.022 ounces
Manufacturer Rain Bird
Material Stainless Steel
Product Dimensions 0.89 x 0.89 x 2.1 inches
Style Pop-Up

3.7

7 Review
5 Star
75
4 Star
20
3 Star
3
2 Star
0
1 Star
2

Uzrakstiet savu atsauksmi

Jūsu e-pasts netiks publicēts. Visi obligātie lauki ir atzīmēti ar*

Scritto da: Eugene
Better near and far spray coverage
To adjust the spray distance and water output of this nozzle, turn the screw on top counterclockwise for an increase, or turn it clockwise for a decrease. To adjust which direction it sprays, you can remove the top of the sprinkler head and reinsert the nozzle tube. Some sprinkler heads are installed deep enough that pulling the top off is undesirable, so you can pull up the nozzle tube and twist it until it's rotated in the right direction. It should make clicking noises as it is turned. If there's no clicking, then you may be unscrewing the sprinkler from the pipe beneath it, or unscrewing the top of the sprinkler, so I prefer to turn it clockwise. I use this nozzle wherever I don't need an adjustable nozzle because it does a better job of providing even coverage both near and far. It works great wherever my sprinklers pop up high enough, which in my lawn requires at least a 4 inch sprinkler. I have a couple 2 inch sprinklers that don't come up enough, so the dual spray part of this nozzle sprays directly into the grass right next to it. It's not the fault of the nozzle, but a notification that I should swap out that sprinkler head. I've also found that this nozzle can directly replace some of the nozzles on my Orbit sprinklers. My only gripe with this nozzle, and all Rain Bird nozzles, is that the adjustment screw tightness has a lot of variation. Sometimes it's so tight that the nozzle must be pulled up and gripped tightly to adjust it, which results in a face full of water if you try this while the sprinklers are on, but other nozzles are loose enough that they can be adjusted just by turning the screw without holding onto the nozzle. Fortunately giving the adjustment screw a few turns to loosen it up before installing it is all it takes to resolve this minor issue.
Scritto da: Eugene
Good near and far spray coverage
To adjust the spray distance and water output of this nozzle, turn the screw on top counterclockwise for an increase, or turn it clockwise for a decrease. To adjust which direction it sprays, you can remove the top of the sprinkler head and reinsert the nozzle tube. Some sprinkler heads are installed deep enough that pulling the top off is undesirable, so you can pull up the nozzle tube and twist it until it's rotated in the right direction. It should make clicking noises as it is turned. If there's no clicking, then you may be unscrewing the sprinkler from the pipe beneath it, or unscrewing the top of the sprinkler, so I prefer to turn it clockwise. I use this nozzle wherever I don't need an adjustable nozzle because it does a better job of providing even coverage both near and far. It works great wherever my sprinklers pop up high enough, which in my lawn requires at least a 4 inch sprinkler. I have a couple 2 inch sprinklers that don't come up enough, so the dual spray part of this nozzle sprays directly into the grass right next to it. It's not the fault of the nozzle, but a notification that I should swap out that sprinkler head. I've also found that this nozzle can directly replace some of the nozzles on my Orbit sprinklers. My only gripe with this nozzle, and all Rain Bird nozzles, is that the adjustment screw tightness has a lot of variation. Sometimes it's so tight that the nozzle must be pulled up and gripped tightly to adjust it, which results in a face full of water if you try this while the sprinklers are on, but other nozzles are loose enough that they can be adjusted just by turning the screw without holding onto the nozzle. Fortunately giving the adjustment screw a few turns to loosen it up before installing it is all it takes to resolve this minor issue.
Scritto da: Dazzza
Great Replacement at Low Cost
These nozzles fit the 1800 series and UNI-Spray series sprinkler head bodies. They will also fit onto most other brands of sprinklers that use universal female thread nozzles. While Rainbird makes a wide range of nozzles, most are only available at specialty irrigation stores. Hardware stores and home centers tend to only carry a few of the most common nozzles. Rainbird makes a very good nozzle set with good water spray uniformity. Many of them have matched precipitation rates so you can mix different radius and pattern nozzles on the same valve zone without messing up the water application uniformity. Be careful of this as Rainbird's literature calls all of their nozzles "matched precipitation rate", but that does not mean they are all compatible with each other! For example, you should not use a 4 series VAN nozzle on the same valve circuit as a 5 series MPR nozzle. Read the nozzle descriptions for each series of nozzles below for details on which nozzles are compatible. The spray radius can be reduced up to 25% on all but a few specialty bubbler nozzles using a screw on top of the nozzle. Note that the separate screen must be installed under the nozzle for the radius adjustment to work correctly. If you remove or don't install the screen you won't be able to adjust the radius. The screens are provided with the nozzles when you purchase them. All Rainbird nozzles are constructed of high-quality plastic.
Scritto da: Padmapada
Easy fix for a damaged sprinkler head, saved lots of $$$
The folks who cut my grass tend to cut the heads off the sprinklers with their machines. In the past, I've called the sprinkler company to fix them, and ended up paying hefty service calls. This time I had a look and saw that the damaged head simply unscrewed. So I went to the local big box store and tried to find a replacement. The clerk tried to talk me into buying something that had threads on the OUTSIDE because, I guess, that is what he had in stock. But I needed a head with threads on the inside, one that would just screw down on top of the pop-up pipe. I saw this on Amazon and asked other customers if it had threads on the inside, and the answer was positive. So I bought this, and it took about 2 minutes to install. The head is clearly marked so that you can see which way the spray goes (this is a half circle), and there is a screw on top to reduce the diameter if you want. It is installed in the berm, or tree lawn, or verge, or curb strip, or whatever you call that narrow strip of lawn between the sidewalk and the street. Perfect. Good for all dialects.
Scritto da: Cindy
Good product
Product fit as described
Scritto da: Amazon Customer
Performance met the product description.
Did a lot better than the water savors you can buy.
Scritto da: Brenda Brennan
Perfect fit
Perfect to replace broken sprinkler head.

Saistītie produkti

Atklājiet mūsu starptautisko tīklu

Mēs piegādājam uz 28 valstīm, vairāk nekā 200 000 produktu. Esiet informēts, abonējiet biļetenu.

Array